active - OmniMark operator

operator

active

Syntax

  (when | unless) active (switch-name indexer?) and/or (switch-name indexer?)*

Purpose

Used in pre-V3 releases to yield and test the value of a switch. In OmniMark V3 and later releases, this operator is no longer required; simply identifying the switch in a when condition is sufficient.

When testing, each active command must use either and or or connectors; both connectors cannot be used in the same active test.

----

[ INDEX ] [ CONCEPTS ] [ TASKS ] [ SYNTAX ] [ LIBRARIES ] [ OMX ] [ ERRORS ]

OmniMark 6.5 Documentation Generated: December 23, 2002 at 6:25:08 pm
If you have any comments about this section of the documentation, send email to [email protected]