Syntax
silent-referent
Purpose
Indicates a silent referent: a referent that is written without its existence being noted on the referents shelf. Silent referents are used when the detection of undefined referents is not required:
output silent-referent "table mark %d(table-mark-count)"
|
|
Related Syntax
|
Related Concepts
|
OmniMark 9.0β Documentation Generated: September 16, 2008 at 1:41:41 pm
If you have any comments about this section of the documentation, please use this form.
Copyright © Stilo International plc, 1988-2008.
